LT HYDRA Plus, Manual

Page: 125 / 258

CROSSFADERS
&
10-9
HYDRA PLUS – LT LIGHT
To retreat to the previous memory, immediately (without fades) press:
PAUSE q GOBACK
To retreat for more than 1 memory, press:
PAUSE
q
GOBACK GOBACK GOBACK... PAUSE
p
These changes to the previous memory or next memory are done in 0,1 seconds .
In masters
To select the desired memory as next memory,
#,
press:
# STEP q Mn
Memory
#
is placed as next memory in master
n
.
To restore the memories list that is loaded in the master
n
, but beginning with a blackout, press:
STEP q Mn
Memory
0
(blackout) is placed as next memory in master
n
.
RATE CONTROL
In crossfaders
A crossfader can be accelerate or decelerate using its speed control. To activate the speed
controls press:
RATE
Now, in the control wheels...
The speed control for the crossfader
X
is in
R1
The speed control for the crossfader
Y
is in
R2
The speed control for the crossfaders
X
&
Y,
at the same
time, are in
R3
Move
R1
to control
Rate X
, and/or press
áá
&
ââ
Move
R2
to control
Rate Y
, and/or press áá & ââ
Move
R3
to control
Rate X+Y
, and/or press
áá
&
ââ
To close the speed controls, press
RATE
again.
The speed value is presented in percentage (%), in the status line of each crossfader. When this
value is not 100% (affecting to the programmed times) is showed in a red field.
To have a rate control at any moment, it’s possible to use a master configured as
RATE
from the
MDFY FLMT
table.
In the example, master 24 is configured as
RATE
of crossfader
X
.