P/N 1389990 Rev B (ECN 32099)
66
Spread Spectrum Installation Guide
Changing Default USB Port Settings
The type of radio assigned to USB1 to USB6 can be updated if necessary.
Contact the Lindsay Service Department to modify the default settings of the
Bridge. The Bridge must be connected to the internet to have the settings
modified. Only one of each type of base radio may be connected to the Bridge.
Hardware
Order the following hardware to connect base radios to the Version 2.0 FieldNET
Bridge:
Base Radio Type
Connection Hardware
FieldNET Spread Spectrum RTU
15-1141-0
KIT,FIELDNET,CABLES,BASE,V2
Online Control Radios
14-9838-0
USB to Serial Port Adaptor
Transparent Mode Radios (Elpro)
14-9838-0
USB to Serial Port Adaptor
Note: Kit 15-1141-0 contains the three parts shown on page 4 to connect a
FieldNET spread spectrum Base RTU to a version 2.0 Bridge (14-9838-0,
15-0848-0 and 15-1135-0). This kit does NOT contain a base RTU.
Bridge Troubleshooting
If the FieldNET Communication Tab (see pg. 2) indicates that the Bridge is not
connected to the internet then cycle power to the modem and routers used to
reach the internet. A monitor and keyboard may be used for additional
troubleshooting.
Connect a monitor and keyboard to the Bridge. Any used USB port may be used
for the keyboard. The Bridge will display a menu to assist in troubleshooting
connectivity issues.
