P/N 1389990 Rev B (ECN 32099)
19
Spread Spectrum Installation Guide
x
SET HOP PATTERN FOR ANTENNA (1) WITH ITEM (3)
x
SET HOP PATTERN FOR ANTENNA (11) WITH ITEM (8)
x
CONFIGURATION SWITCHES (3) AND CONFIGURATION SWITCHES (8)
MUST BE SET TO DIFFERENT HOP PATTERNS
FieldNET Repeater Components
1 - Antenna Connector (connect antenna for left
radio module)
2 - Rx/Tx LEDs (left)
3 - Configuration Switches (use to set hop pattern
for left radio module)
4 - Signal Strength Switch (left)
5 - Mesh LED
6 - Signal Strength LEDs
7 - Signal Strength Switch (right)
8 - Configuration Switches (use to set hop pattern
for right radio module)
9 - Rx/Tx LEDs (right)
10 - Power LED
11 - Antenna Connector (connect antenna for right
radio module)
12 - Repeater Power Cable Connector
(connects Repeater to power supply)
Switch 4 must be in the rightmost "OFF" position as shown.
Switches 1 to 3 are used to select hop patterns 0 to 7.
