P/N 1389990 Rev B (ECN 32099)
53
Spread Spectrum Installation Guide
I/O LEDs
The four I/O LEDS are used when the RTU is connected to a Basic Link.
x
LED
1
–
Start Command
x
LED
2
–
Stop Command
x
LED
3
–
Forward
x
LED
4
-
%
Timer
When the web portal sends a START command LED 1 will turn on for 8 seconds.
While LED 1 is ON the start relay on the Basic Link is engaged and the system
will attempt to start. After 8 seconds the start relay will automatically disengage.
When the web portal sends a STOP command LED 2 will turn on for 8 seconds.
While LED 2 is ON the stop relay on the Basic Link is engaged and the system
will attempt to stop. After 8 seconds the stop relay will automatically disengage.
LED 3 is ON when the Forward line has 120 VAC and LED 4 is on when the %
Timer line has 120 VAC.
Power LED
The power LED should be ON whenever the RTU has 12 VDC.
RTU Cable Connection
The FieldNET RTU is connected to FieldBOSS/FieldVISION panels through a
two part cable. One half is mounted to the bottom of the control panel and the
other is plugged into the RTU and threaded into the bottom of the control panel.
FieldNET RTUs are connected to Basic Links with a one part cable. Both data
and power is sent though this cable.
Device ID
Each RTU has a unique device ID programmed into it from the factory. The Web
Portal uses this Device ID to identify the RTU. When a new RTU is connected to
a control panel, powered up and meshes with a Base RTU connected to an
operational Bridge with an active Internet connection, the new RTU is added to
the device list on the Web Portal. The device ID is printed on a label on the
inside of the RTU. When a new device is registered on the web portal it is
identified by the Device ID of the RTU. The new device can be renamed with the
web portal on the properties section of the Vision Zone.
