Lexmark T63 Series, Service Manual

Page: 152 / 345

3-24
Service Manual
4060- xxx
Paper jams—options
Error Message 23 x Paper Jam - Check Duplex Option
The paper is most likely jammed in the duplex option, however the paper can also be jammed in the
redrive at the input to the duplex option. The redrive assembly may not be correctly installed or
locked in position or the duplex link is bent and not aligned properly to allow paper to feed correctly
into the duplex option. Use the specific errors below:
•
231 Duplex Paper Jam - Rear —A piece of media did not arrive at the duplex input sensor, but
did leave the printer exit sensor.
•
232 Duplex Paper Jam - Rear —A piece of media did not clear the duplex input sensor but did
leave the printer exit sensor.
•
233 Duplex Paper Jam - Rear —A piece of media failed to make the duplex doublefeed sensor
during turnaround.
•
234 Duplex Paper Jam - Rear —The media did not reach the duplex exit sensor.
•
235 Duplex Paper Jam - Front —A piece of media is over the duplex doublefeed sensor.
•
236 Duplex Paper Jam - Front —A piece of media did not leave the duplex exit sensor.
•
237 Duplex Paper Jam - Front —A piece of media did not reach the printer input sensor.
•
238 Duplex Paper Jam —A piece of media is over one of the duplex sensors during a reset.
•
239 Duplex Paper Jam —A paper jam has occurred in the duplex option.
Note: When the StapleSmart finisher is installed, a secondary message may be displayed which
advises whether or not to remove the job from the finisher. If a job has accumulated in the finisher,
then the printer alternately flashes the primary and secondary messages to indicate that all
accumulated sheets should not be removed during the jam clearance procedure. If the sheets are
removed, then the printer does not reprint these sheets.
231 Paper Jam
Input Sensor
232 Paper Jam
Stage 1
Location
Doublefeed Sensor
Stage 2
Location
233 Paper Jam
235 Paper Jam
234 Paper Jam
236 Paper Jam
Exit Sensor
235 Paper Jam
237 Paper Jam