Lexmark T63 Series, Service Manual

Page: 82 / 345

2-48
Service Manual
4060- xxx
Duplex does not recognize that the option is installed, or other options below
the duplex are installed
Note: Before proceeding with the following service checks, verify the media used in the duplex
option meets specification and is not dog-eared or damaged in any way. See “Media
specifications” on page 1-8 .
231 Jam displays on the operator panel
232 Jam displays on the operator panel
233 Jam displayed on operator panel
FRU Action
1 Autoconnect cables/
connections Check the top and bottom autoconnect connectors for signs of
damage. If damaged, replace the duplex option. If not damaged,
check the cables are correctly connected to the duplex system board
at J9, J10, J11, and J12. If no problem is found, replace the duplex
option.
FRU Action
1 Fuser exit sensor Check the sheet of media is leaving the exit sensor in the fuser and
feeding properly into the duplex option. Check the duplex link for
correct operation and any signs of damage. If the problem is prior to
the duplex input sensor and in the base machine, repair as
necessary. If the jam occurs in the duplex option prior to the duplex
input sensor, go to step 2.
2 Duplex input sensor If the paper does not reach the duplex input sensor, make sure the
sensor is connected to the duplex system board. If correct, check for
any paper or other objects that might cause a paper jam. If none are
found, replace the duplex option assembly.
FRU Action
1 Duplex input sensor If the paper reaches the duplex input sensor, but does not clear the
sensor, make sure the sensor is connected to the duplex system
board. If connected correctly, check for correct operation of the
sensor. If a problem is found and cannot be corrected, replace the
duplex option assembly. If no problem is found, check for a piece of
paper or other object in the paper path that might cause a paper jam
over the input sensor. If no problem is found, replace the duplex
option assembly.
FRU Action
1 Duplex double feed sensor If a sheet of paper fails to reach the double feed sensor during
turnaround, check for any signs of paper or other objects that might
cause the paper to jam. If no problem is found, replace the duplex
option assembly.