LevelOne ProCon GSW-1290, User Manual

Page: 92 / 144

LevelOne GSW-1290 Gigabit Layer2 SNMP Switch
The following parameters can be set:
Parameter Description
Profile ID(1-255)
Type in a unique identifier number for this profile set or allow an ID to be
automatically assigned by checking the Auto Assign option. This value
can be set from
1 to 255 .
Type
Select profile based on Ethernet (MAC Address) or IP address. This will
change the menu according to the requirements for the type of profile.
Select
Ethernet to instruct the Switch to examine the layer 2 part of each
packet header. Select IP to instruct the Switch to examine the IP address
in each frame’s header.
Vlan
Selecting this option instructs the Switch to examine the VLAN part of
each packet header and use this as the, or part of the criterion for
forwarding.
Source IP Mask Source IP Mask - Enter an IP address mask for the source IP address.
Destination IP Mask
Destination IP Mask - Enter an IP address mask for the destination MAC
address.
Dscp
Selecting this option instructs the Switch to examine the DiffServ Code
part of each packet header and use this as the, or part of the criterion for
forwarding.
Protocol
Selecting this option instructs the Switch to examine the protocol type
value in each frame’s header. You must then specify what protocol(s) to
include according to the following guidelines:
Select ICMP to instruct the Switch to examine the Internet Control
Message Protocol (ICMP) field in each frame’s header.
Select type to further specify that the access profile will apply an ICMP
type value, or specify code to further specify that the access profile will
apply an ICMP cod value.
Select IGMP to instruct the Switch to examine the Internet Group
Management Protocol (ICMP) field in each frame’s header.
Select type to further specify that the access profile will apply an IGMP
type value
Select TCP to use the TCP port number contained in an incoming packet
as the forwarding criterion. Selecting TCP requires that you specify a
source port mask, a destination port mask or a flag bite.
src port mask
−
Specify a TCP port mask for the source port in hex form
(hex 0x0-0xffff).
dest port mask
−
Specify a TCP port mask for the destination port in hex
form (hex 0x0-0xffff).
flag bite – Specify a flag bite in the TCP header.
Select UDP to use the UDP port number contained in an incoming packet
as the forwarding criterion. Selecting UDP requires that you specify a
source port mask and/or a destination port mask.
src port mask
−
Specify a TCP port mask for the source port in hex form
(hex 0x0-0xffff).
dest port mask
−
Specify a TCP port mask for the destination port in hex
form (hex 0x0-0xffff).
protocol id
−
Specify a TCP port mask for the destination port in hex form
(hex 0x0-0xffffffff).
Mode Select Permit to specify that the packets that match the access profile are
f
S (
92