LevelOne GSW-1290 Gigabit Layer2 SNMP Switch
Ping Test
PING is a small program that sends data packets to the IP address you specify. The destination node then
returns the packets to the Switch. This is very useful to verify connectivity between the Switch and other
nodes on the network.
Figure 8- 5. Ping Test window
The
Infinite times
checkbox, in the
Number of Repetitions
field, tells PING to keep sending data packets
to the specified IP address until the program is stopped.
Save Changes
The GSW-1290 has two levels of memory; normal RAM and non-volatile or NV-RAM. Configuration
changes are made effective clicking the
Apply
button.
When this is done, the settings will be immediately
applied to the Switching software in RAM, and will immediately take effect.
Some settings, though, require you to restart the Switch before they will take effect. Restarting the Switch
erases all settings in RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save
all setting changes to NV-RAM before rebooting the Switch.
To retain any configuration changes permanently, click the
Save
Configuration
button in window below.
Figure 8- 6. Save Configuration window
Once the Switch configuration settings have been saved to NV-RAM, they become the default settings for
the Switch. These settings will be used every time the Switch is rebooted.
140
Summary of Contents for ProCon GSW-1290
