LevelOne ProCon GSW-1290, User Manual

Page: 90 / 144

LevelOne GSW-1290 Gigabit Layer2 SNMP Switch
Figure 4- 40. Access Profile Configuration (Ethernet) menu
The following parameters can be set for Ethernet type Access Profile configurations:
Parameter Description
Profile ID(1-255) Type in a unique identifier number for this profile set or allow an ID to be
automatically assigned by checking the Auto Assign option. This value
can be set from
1 to 255 .
Type Select profile based on Ethernet (MAC Address) or IP address. This will
change the window according to the requirements for the type of profile.
Select
Ethernet to instruct the Switch to examine the layer 2 part of each
packet header. Select IP to instruct the Switch to examine the IP address
in each frame’s header.
Vlan Selecting this option instructs the Switch to examine the VLAN part of
each packet header and use this as the, or part of the criterion for
forwarding.
Source Mac Source MAC Mask - Enter a MAC address mask for the source MAC
address.
Destination Mac Destination MAC Mask - Enter a MAC address mask for the destination
MAC address.
802.1p Selecting this option instructs the Switch to examine the 802.1p priority
value of each packet header and use this as the, or part of the criterion
for forwarding.
Ethernet type Selecting this option instructs the Switch to examine the Ethernet type
value of each packet header and use this as the, or part of the criterion
for forwarding.
Mode
Select Permit to specify that the packets that match the access profile are
forwarded by the Switch, according to any additional rule added (see
below).
Select Deny to specify that packets that do not match the access profile
are not forwarded by the Switch and will be filtered.
The page shown below is the Access Profile Configuration menu for IP.
90