LevelOne GSW-1290 Gigabit Layer2 SNMP Switch
connection must have “active” LACP ports.
After setting the previous parameters, click
Apply
to allow your changes to be implemented. The LACP
Port Table shows which ports are active and/or passive.
IGMP
In order to use IGMP Snooping it must first be enabled for the entire Switch (see
Advanced Settings
). You
may then fine-tune the settings for each VLAN using the
IGMP Snooping Settings
window. When
enabled for IGMP snooping, the Switch can open or close a port to a specific Multicast group member
based on IGMP messages sent from the device to the IGMP host or vice versa. The Switch monitors IGMP
messages and discontinues forwarding multicast packets when there are no longer hosts requesting that
they continue.
IGMP Snooping
Use this window to view IGMP Snooping status. To modify settings, click the
Modify
button for the
VLAN ID you want to change.
Figure 4- 7. Current IGMP Snooping Group Entries table
Click the
Modify
button to bring up the
IGMP Snooping Settings
window pictured below.
56
Summary of Contents for ProCon GSW-1290
