Lenovo 7D7Q, Maintenance Manual

Page: 105 / 184

1. Install the PCIe riser assembly. See “Install the PCIe riser assembly” on page 101 .
2. Install the top cover. See “Install the top cover” on page 134 .
3. If necessary, configure the RAID array using the Setup utility configuration.
4. Complete the parts replacement. See
“Complete the parts replacement” on page 140 .
Remove the PCIe adapter (Slot 3)
Use this information to remove the PCIe adapter from PCIe slot 3.
About this task
Attention:
• Replacing the RAID adapter might impact your RAID configurations. Back up your data before the
replacement to avoid any data loss due to a RAID configuration change.
• Read the following section(s) to ensure that you work safely.
– “Safety” on page iii
– “Installation Guidelines” on page 51
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 11 .
• If the server is installed in a rack, remove the server from the rack.
Note:
The following illustration might differ slightly from your hardware, but the removal method is the same
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 132 .
Step 2. Remove the PCIe adapter.
Chapter 4
.
Hardware replacement procedures
97