Rigging procedures
10.
Detach SB18#3 from SB18#2 as follows:
a) Disconnect a T-BLP from the bottom of SB18#2.
b) Rotate the rigging arm down.
c) Re-connect the T-BLP to SB18#3 so as to lock the rigging arm in closed position.
d) Repeat this procedure until all 4 arms are locked in closed position.
11.
Raise the array so that SB18#2 is separated from SB18#3.
12.
Attach two dolly boards to SB18#3 and 4.
13.
Detach SB18#4 from SB18#3 by applying step
(p.78).
14.
Remove SB18#3 and 4 from the rigging location.
15.
(p.77) to 14 to separate the SB18s from the array just until SB18#1 and 2 are remaining attached
to the M-BUMP.
16.
Lower the array until it rests on the ground.
17.
Remove the motor hook(s) or stinger(s) from the shackle(s) of the M-BUMP.
78
Kara owner's manual (EN) version 1.0
