L-Acoustics LA-RAK, Owner'S Manual

Page: 103 / 201

Rigging procedures
Procedure
1. Assemble a KARA-MINIBU/KARA-MINIBUEX stacking platform as follows:
a) Turn the KARA-MINIBU so that the text of the identication plate is upside down.
b) Position a rst KARA-MINIBUEX on the laser plate side of the KARA-MINIBU by turning the KARAMINIBUEX feet
pointing down and inserting the stud into the slit of the KARA-MINIBU located near the laser plate.
c) Drive 3 bolts to the 3 holes shown in the gure below (6 mm hex bit, 13 mm hex key, 7 N.m/63 in.lb f ).
d) Repeat the procedure with a second KARA-MINIBUEX on the other side of the KARA-MINIBU.
2.
If KARA-ANGARMEX are intended to be used (see Array site angle setting (p.198)), attach two KARA-ANGARMEX
to the platform as follows:
a) Remove an R-BLP from a rear corner of the KARA-MINIBU.
When using KARA-ANGARMEX the platform must be put in front extension conguration (see Stacking
platform conguration (p.197)).
b) Insert the single part of a rst KARA-ANGARMEX into the corner slit: position it vertically with sling ring towards
the front and indentation resting on the spacer.
c) Align the KARA-ANGARMEX and KARA-MINIBU holes and secure them together by re-inserting the R-BLP.
d) Repeat the procedure with a second KARA-ANGARMEX on the other rear corner of the KARA-MINIBU.
3. Remove both front R-BLP from the KARA-MINIBU.
The front and rear sides are dened according to the chosen conguration.
4. If KARA-ANGARMEX are attached to the KARA-MINIBU, remove both T-BLP from them. Otherwise, remove both rear
R-BLP from the KARA-MINIBU.
5.
Bring a full Kara ight-case to the stacking location and remove the lid. In the following, the enclosures will be
designated as KARA#1 to KARA#3 from top to bottom.
Kara owner's manual (EN) version 1.0 103