Rigging procedures
7.
With two people working simultaneously on each side of the array, remove both rear rigging points between
ARRAY#1 and ARRAY#2 as follows:
a) While grabbing the back handle of KARA#5, remove the rear bottom link R-BLP from KARA#3 and re-insert it into
the bottom storage hole.
b) Rotate ARRAY#2 downwards and place the rear corners into the tray while still suspended from the front rigging
points.
c) Remove the rear top angle R-BLP from KARA#4, slide the angle arm so as to align the cursor with the storage
position, and re-insert the R-BLP into the top storage hole.
8.
Lower the array until ARRAY#2 rests in the tray and the front rigging points between ARRAY#2 and ARRAY#1 are in
contact.
9.
Remove the front rigging points between ARRAY#1 and ARRAY#2 as follows:
a) Remove both KARA#4 front top link R-BLP.
b) Slightly raise ARRAY#1.
c) Remove both KARA#3 front bottom link R-BLP and re-insert them into the bottom storage holes.
d) Rotate both KARA#4 front arms down and re-insert both R-BLP into the top storage holes.
10.
Push ARRAY#2 away from the rigging location and put the ight-case lid on.
11.
(p.56) to 10 to remove the ARRAYs just until ARRAY#1 is remaining attached to the M-BUMP.
12.
Lower the array to a height for which the angle arms of ARRAY#1 are within comfortable reach and set the angles to
0° by applying step
(p.56).
Kara owner's manual (EN) version 1.0
57
