Rigging procedures
6.
On KARA#1, take the 4 arms out as follows (repeat for each side):
a) Remove the front top R-BLP from storage position, rotate the front arm up, slide it down, and secure by reinserting
the R-BLP into the yellow link hole.
b) Remove the rear top R-BLP, slide the angle arm so as to align the cursor with the 5° angle value, and secure by re-
inserting the R-BLP into the corresponding angle hole (1°/3°/5°/7.5°/10°).
It is recommended to select the 5° angle on the Kara intended to be linked to the M-BUMP. In that way the
KARA#1 axis will be parallel to the M-BUMP.
a.
b.
7.
Remove the 4 R-BLP from the M-BUMP, put the M-BUMP on ARRAY#1 by aligning the four rigging points, and secure
by re-inserting the 4 R-BLP.
8.
Place ARRAY#1 beneath the rigging points, attach the motor hook(s) or stinger(s) to the shackle(s), raise the array
to a height for which the angle arms of ARRAY#1 are within comfortable reach, and remove the ight-case from the
rigging location.
52
Kara owner's manual (EN) version 1.0
