Rigging procedures
3.
Open the four KARA#1 arms as follows (repeat on both sides of the enclosure):
a) Remove the front top R-BLP from its
storage
hole, rotate the front arm up, slide it down, and lock it in place by
re-inserting the R-BLP into its
link
hole.
The front top
storage
and
link
holes are the same.
b) Remove the rear top R-BLP from its
storage
hole, slide the angle arm so as to align the cursor with angle label
5°, and lock it in place by re-inserting the R-BLP into angle hole 1°/3°/5°/7.5°/10°.
It is recommended to select the 5° angle on the Kara intended to be attached to the KARA-MINIBU; in that
way the KARA#1 axis will be parallel to the KARA-MINIBU.
a.
b.
4.
Attach a KARA-MINIBU to KARA#1 as follows:
a) Remove the four R-BLP from the KARA-MINIBU.
b) Turn the KARA-MINIBU so that the text of the identication plate is readable and the laser plate is placed at the
front (towards audience).
c) While keeping this orientation, align the four link points of KARA-MINIBU with the four arms of KARA#1 and
secure each pair together by re-inserting the four R-BLP into the same holes (insert both rear R-BLP rst).
Kara owner's manual (EN) version 1.0
61
