Rigging procedures
If KARA-MINIBUEX rigging plates are already mounted to the KARA-MINIBU (see Array mounting, step
(p.81)), it is not necessary to remove them: the KARA-MINIBU/KARA-MINIBUEX rigging structure can also
be used in place of the KARA-MINIBU.
5.
Attach the shackle(s) to the KARA-MINIBU (see
Safety pin removal and insertion
(p.199)) according to the chosen
conguration (see
(p.192)).
If the array is intended to be own in pullback conguration, attach a single shackle to the rear pullback hole
(see
(p.19)).
6.
Place ARRAY#1 beneath the rigging points and attach the motor hook(s) or stinger(s) to the shackle(s).
7.
Raise the array to a height for which the angle arms of ARRAY#1 are within comfortable reach and remove the ight-
case from the rigging location.
8.
With two people working simultaneously on each side of ARRAY#1, set the inter-enclosure angles as follows:
a) While grabbing the back handle of KARA#3, remove the KARA#2 rear top R-BLP from angle hole 0°/2°/4°.
b) Rotate KARA#2 so as to align the angle arm cursor with the chosen angle label.
c) Lock KARA#2 in place by re-inserting the R-BLP into the corresponding angle hole (0°/2°/4° or
1°/3°/5°/7.5°/10°).
d) Repeat the procedure for KARA#3.
62
Kara owner's manual (EN) version 1.0
