Rigging procedures
Array removal
About this task
All along the procedure:
Strictly follow the sequence of the successive steps.
Systematically verify that each BLP is fully inserted.
For clarity purposes the loudspeaker cable removal procedure will not be described.
The loudspeaker cables will not be represented on the gures.
Procedure
1.
In case of SB18 standalone array, directly go to step
(p.77).
In case of SB18/Kara mixed array, begin the procedure by applying the Kara standalone array removal procedure,
steps
(p.56) to 13, and then continue to next step.
2.
Lower ARRAY#1 into the tray. The bottom SB18 must be resting on the M-BUMP.
3.
Disconnect the 4 rigging points between the bottom SB18 and the M-BUMP as follows (repeat for each point):
a) Remove the T-BLP from the M-BUMP.
b) Rotate the arm down.
c) Re-insert the T-BLP on the M-BUMP.
4.
Push ARRAY#1 away from under the SB18 array.
5.
Remove the 4 R-BLP from the M-BUMP and remove the M-BUMP from ARRAY#1.
76
Kara owner's manual (EN) version 1.0
