7
7-36
Care and Maintenance
The back of the printed page appears dirty.
The print quality of a transparency is poor.
Corrective Action:
Print the Color Calibration Page from the Color Calibration menu in the printer
panel. Check the density settings for each color and compare them to the
examples on the Color Density Samples. Refer to Setting the Color Density on
page 54 for instructions on comparing and setting color density.
Make sure that the imaging unit stays covered until immediately before installing
it in the printer. Exposure to light for more than 45 seconds can damage the
imaging unit.
Make sure that the toner cartridges are installed correctly.
Make sure that you use a high-quality laser paper: 60-105 g/m
2
(16-28 lbs.) paper
in the media trays and 75-165 g/m
2
(20-44 lbs.) paper in the multi-purpose tray.
When using the multi-purpose tray, make sure that you have selected the correct
media type in the driver or in the Menu mode of the printer panel.
Most spots are caused by fingerprints or dust introduced into the printer while
installing the imaging unit or loading media. Make sure that the surface where
you unpack the imaging unit, paper, and transparencies is free of dust. Keep
supplies in a covered area or a closed box.
Make sure that the imaging unit stays covered until immediately before installing
it in the printer. Exposure to light can damage the imaging unit and will produce
light streaks or faded prints.
Do not touch the right side or underside of the imaging unit; fingerprints affect
print quality.
Make sure that the paper or transparency film is clean.
Summary of Contents for Ci1000
