Kyocera Ci1000, Operating Instructions Manual

Page: 124 / 214

6
6-24 Setup from the Control Panel and WebSetup
The Port Setup tab is the first tab displayed in Network Setup. You can also access
Protocol Setup, PServer Setup, and Service Setup tabs from this window. After
setting all the options in the Port Setup tab, click the next tab and continue to
specify settings until you have made settings for all relevant options in the
Network Setup category.
Port Setup tab
The options that you can set from the Port Setup tab are described below.
Enable Ethernet
—Enable this option if the Ci1000 is to be connected to an
Ethernet network.
Transmission Speed
—Select
Auto Detect
if your network environment is mixed,
or select the speed (10 Mbps or 100 Mbps) of the network to which the Ci1000 is
attached.
Enable Parallel Port
—Enable this option if you want to print through the parallel
port. You can connect a single Windows computer to the parallel port and print
directly to the Ci1000.
N
OTE
:
Enabling the parallel port does not conflict with Ethernet or Token Ring
communication with the Ci1000.
Ignore EOF Character
—Available only if Enable Parallel Port is enabled, this
option specifies that the Ci1000 should ignore end-of-file (EOF) messages.
Enabling this option is required to print PostScript files in binary format (not
ASCII); under normal circumstances, this option should not be enabled. When
this option is enabled, the Ci1000 uses the parallel port timeout value to
determine when the end of the file has been reached.
Parallel Port Timeout (Seconds)
—Available only if Enable Parallel Port is enabled,
this option’s setting determines how long the Ci1000 waits without receiving data
from the parallel port before deciding that the current job is complete. Until the
timeout, the Ci1000 cannot receive new jobs through the parallel port, but it can
continue to receive network print jobs.