Preparation for use
67
Changing to 0 knives
Focus
> Push to I
> Push to enter the working display
> Push to select knife control
Tellus
> Push to I
> Push to enter the working display
> Push to select knife control
> Open valves at the hydraulic block on the left side
> Move the hydraulic valve to depressurize the cutting system
All knives will extract.
Cutting length
The cutting length can be chosen as desired, by varying the amount
and the position of the knives.
Minimum cutting length:
•
14 knives: about 70 mm
•
23 knives: about 50 mm
Exchange of
knives by dummy
knives [+]
Once the knives are removed, they can be replaced by dummy knives.
Which helps to
•
keep the knife slots clean
•
ensure an uniform crop flow over the cutting system floor
To install the dummy knives
→
Installing the knives, page 62
GP0425
Open
Summary of Contents for Vicon RV 2160
