240
Troubleshooting
Error messages -
Focus
The buzzer warns when an error occurs. Every error indication ap-
pears separately on the control box display in order of priority.
If an error occurs:
> Stop baling immediately
> Remedy the error before continuing work
Igno ring the fault message and continuing work may cause consid-
erable material and financial damage!
Net not running
This message appears when the net is not running although it should
do so.
> Check if the net has been broken
The net is not running although it should do so. This is indicated some
seconds after initiation of the wrapping procedure.
> Check the net routing
> Correct the net routing if necessary
Net running
This message appears when the net is running although it should not
.
> Check if the net has been cut
> Check whether the net is pulled by the bale
Twine tubes position
This message appears when:
•
no twine binding device is available at the machine
•
the twine tubes do not move due to a blockage
•
the twine tubes do not move due to an electrical storage
•
the twine tubes do move but a sensor failure
Summary of Contents for Vicon RV 2160
