Kubota ME8200DTN, Workshop Manual Supplement

Page: 91 / 192

ME8200DTN, WSM TRANSMISSION
N3-S27
Disassembling PTO Gear Case
1. Remove the PTO case cover mounting screws and then
remove the PTO gear case cover (6).
2. Remove the stake of the staking nut (8), and then remove it.
3. Remove the bearing (7) by using the bearing puller.
4. Tap out the PTO shaft to the rear side.
5. Remove the gears (11), (14), thrust collars (9), (17), inner
rings (10), (15), hub (13) and shifter (12).
6. Pull out the PTO drive shaft (1) as a unit.
7. Remove the PTO shift fork parts and PTO shift lever parts.
(When reassembling)
A
Reinstall the reamer screw at correct position to mount the
PTO cover case.
A
Direct the grooves of thrust collars (9), (17) to the inner rings
(10), (15) sides.
A
Replace the PTO shaft staking nut (8) with new one, and stake
it firmly after tightening.
A
Apply molybdenum disulfide (Three Bond 1901 or equivalent)
to the inner rings (10) and (15).
A
Apply grease to the oil seal (19) and O-ring.
Tightening torque
PTO shaft staking nut
225.6 to 264.8
23 to 27
166.4 to 195.3 ft-lbs
PTO gear case cover
mounting screws and
reamer screw 77.5 to 90.2
7.9 to 9.2
57.1 to 66.5 ft-lbs
(1) PTO Drive Shaft (11) Gear
(2) Ball Bearing (12) Shifter
(3) Gear (13) Hub
(4) Gear (14) Gear
(5) Ball Bearing (15) Inner Ring
(6) PTO Gear Case Cover (16) Internal Snap Ring
(7) Ball Bearing (17) Thrust Collar
(8) Stake Nut (18) Ball Bearing
(9) Thrust Collar (19) Oil Seal
(10) Inner Ring (20) PTO Shaft
0000001938E
KiSC issued 04, 2006 A