Kubota ME8200DTN, Workshop Manual Supplement, Page: 77 / 192

ME8200DTN, WSM TRANSMISSION
N3-S13
Speed Change Cover
1. Remove the speed change cover (1).
(When reassembling)
A
When reassembling the speed change cover (1), set the
shifter and fork in neutral position.
A
Apply liquid gasket (Three Bond 1216 or equivalent) to seam
of speed change cover and clutch housing.
A
Install the main shift cam (2) to main shift shaft (5), aligning the
marks A on them.
Clutch Release Bearing
1. Draw out the release bearing (1) and the release hub (2)
together.
2. Remove the release fork setting screw (4).
3. Draw out the control shaft (3) to take out the release fork (5).
(When reassembling)
A
After tightening the release fork setting screw to the specified
torque, insert a wire through the holes of the setting screw
head and release fork.
A
Apply grease to the sliding surface of the clutch release hub.
A
Apply grease to the bushing of control shaft.
Tightening torque
Speed change cover
mounting screw
23.5 to 27.5
2.4 to 2.8
17.4 to 20.3 ft-lbs
(1) Speed Change Cover (4) Screw
(2) Main Shift Cam (5) Main Shift Shaft
(3) Main Shift Shaft Stopper A : Aligning Mark
0000003469E
Tightening torque
Release fork setting
screw
166.7 to 186.3
17.0 to 19.5
122.9 to 137.4 ft-lbs
(1) Release Bearing (4) Release Fork Setting Screw
(2) Release Hub (5) Release Fork
(3) Control Shaft
0000003470E
KiSC issued 04, 2006 A