Kubota ME8200DTN, Workshop Manual Supplement

Page: 80 / 192

ME8200DTN, WSM TRANSMISSION
N3-S16
Shift Levers and Bearing Retainer
1. Remove the shift lever stopper (1).
2. Tap out the spring pin (4) from Creep shift lever (2).
3. Draw out the Creep shift lever (2).
4. Tap out the spring pin (5) from Hi-Low shift lever (3).
5. Draw out the Hi-Low shift lever (3).
6. Remove the bearing retainers (6).
(When reassembling)
A
Apply grease to the O-ring.
Shift Rods and Forks (1-2), (3-4)
1. Remove the lock screw (12), and take out the springs (5), (7)
and balls (4), (8).
2. Tap out the spring pins (2), (10) from shift forks (1) and (11).
3. Draw out the shift rod (3) and (9).
4. Take out the shift forks (1) and (11).
(When reassembling)
A
Apply grease to the ball and spring.
A
Take care of installing the inter-locking ball (6).
A
Apply liquid lock (Three Bond 1372 or equivalent) to the lock
screws (12).
Tightening torque
Bearing retainer
mounting screw
29.4 to 34.3
3.0 to 3.5
21.7 to 25.3 ft-lbs
(1) Stopper (4) Spring Pin
(2) Shift Lever (Creep) (5) Spring Pin
(3) Shift Lever (Hi-Low) (6) Bearing Retainer
0000002753E
(1) Shift Fork (1-2) (7) Spring
(2) Spring Pin (8) Ball
(3) Shift Fork Rod (1-2) (9) Shift Fork Rod (3-4)
(4) Ball (10) Spring Pin
(5) Spring (11) Shift Fork (3-4)
(6) Inter-locking Ball (12) Lock Screw
0000002754E
KiSC issued 04, 2006 A