Kubota ME8200DTN, Workshop Manual Supplement

Page: 138 / 192

ME8200DTN, WSM FRONT AXLE
N6-S11
Spiral Bevel Pinion Shaft and Differential Gear Assembly
1. Take out the differential yoke shaft (9), (10) both sides.
2. Remove the oil seal (6) and internal snap ring (5).
3. Remove the collar (4).
4. Remove the spiral bevel pinion shaft (3) by the pinion shaft
remover (14). (See page NG-13.)
5. Take out the differential gear assembly (2), ball bearing (7)
and shim (8) from left side of front axle case (1).
6. Remove the stake of lock nut (11), and then remove the lock
nut (11).
7. Remove the taper roller bearings (12).
(When reassembling)
A
Replace the lock nut (11) and oil seal (6) with new ones.
A
Apply grease to the oil seal (6).
A
Install the shims and collars to their original position.
A
Install the taper roller bearings correctly, noting their direction
and apply gear oil to them.
A
When press-fitting an oil seal (6), observe the dimension "A"
described in the figure.
A
After adjusting the turning torque, stake the lock nut (11)
firmly.
Turning torque of spiral
bevel pinion shaft
Factory spec.
0.98 to 1.18
0.10 to 0.12
0.72 to 0.87 ft-lbs
(1) Front Axle Case (10) Differential Yoke Shaft L.H.
(2) Differential Gear Assembly (11) Lock Nut
(3) Spiral Bevel Pinion Shaft (12) Taper Roller Bearing
(4) Adjusting Collar (13) Collar
(5) Internal Snap Ring (14) Pinion Shaft Remover
(6) Oil Seal
(7) Ball Bearing A : Dimension A : 1.0 mm
(8) Shim (0.039 in.)
(9) Differential Yoke Shaft R.H.
0000003536E
KiSC issued 04, 2006 A