Kubota ME8200DTN, Workshop Manual Supplement

Page: 88 / 192

ME8200DTN, WSM TRANSMISSION
N3-S24
Disassembling Clutch
1. Remove the internal snap ring (1), and then take out the clutch
discs (2), the pressure plate (6), and the drive plate (7), (8), (9)
and (10).
2. Remove the piston (3) and O-ring (5) by compression air.
3. Remove the parts for other side as above.
(When reassembling)
A
Install the clutch discs (2) and drive plate (7), (8), (9) and (10)
mutually.
A
When installing the internal snap ring (1), (19) to the clutch
body, align its split portion to the notched portion clutch body.
A
Apply enough transmission fluid to the discs (2), (11).
A
Do not confuse the two types drive plate : The drive plates with
the plug rubbers (20) are (7), (9) and without plug rubbers (20)
are (8) and (10).
A
Do not confuse the pressure plate (6), (18) and drive plates.
The pressure plate (6), (18) is thicker than the drive plates.
A
Confirm the moving of the piston (3), (4) smoothly when
pressure air at 0.5 to 1.0 MPa (5 to 10
, 71 to 142 psi)
is sent to clutch pack.
(1) Internal Snap Ring (11) Clutch Disc
(2) Clutch Disc (12) Drive Plate
(3) Piston (13) Drive Plate
(4) Piston (14) Drive Plate
(5) O-ring (15) Drive Plate
(6) Drive Plate (16) Drive Plate
(7) Drive Plate (17) Drive Plate
(8) Drive Plate (18) Drive Plate
(9) Drive Plate (19) Internal Snap Ring
(10) Drive Plate (20) Plug Rubber
0000003483E
KiSC issued 04, 2006 A