Kubota ME8200DTN, Workshop Manual Supplement

Page: 132 / 192

ME8200DTN, WSM FRONT AXLE
N6-S5
Propeller Shaft
1. Slide the propeller shaft covers (3), (18) after removing the
screw (2), (13).
2. Tap out the spring pins (6), (8) and then slide the couplings (5),
(19) to the front and rear to take out the propeller shaft (7).
(When reassembling)
A
Apply grease to the O-rings, propeller shaft and pinion shaft.
A
Tap in the spring pins (6), (8) as shown in figure.
Power Steering Hoses
1. Disconnect the power steering hoses (2), (3) from steering
cylinder.
2. Remove the cylinder cover (1).
(When reassembling)
(1) O-ring (11) O-ring
(2) Screw (12) Cover Bracket
(3) Front Shaft Cover (13) Screw
(4) O-ring (14) Bearing
(5) Coupling (15) Internal Snap Ring
(6) Spring Pin (16) O-ring
(7) Propeller Shaft (17) Screw
(8) Spring Pin (18) Rear Shaft Cover
(9) Middle Shaft Cover (19) Coupling
(10) Screw (20) O-ring
0000003408E
Tightening torque
Power steering hose
retaining nut
24.5 to 29.4
2.5 to 3.0
18.1 to 21.7 ft-lbs
Cylinder cover
48.1 to 55.8
4.9 to 5.7
35.5 to 41.2 ft-lbs
(1) Cylinder Cover (3) Power Steering Hose 2
(2) Power Steering Hose 1
0000003527E
KiSC issued 04, 2006 A