Kubota ME8200DTN, Workshop Manual Supplement

Page: 71 / 192

ME8200DTN, WSM TRANSMISSION
N3-S7
Piping for 3-Point Hydraulic System
1. Remove the accelerator rod (1).
2. Remove the suction pipe (3).
3. Remove the delivery pipe (4) for 3-point hydraulic system.
4. Remove the delivery pipe (2) for power steering.
Wiring Harness R.H. and Fuel Pipes
1. Disconnect the 3P connector for solenoid valve (3).
2. Disconnect the wiring lead (2) from the glow plug.
3. Disconnect the coolant thermo sensor 1P connector (1).
4. Remove the fuel pipes (4).
Wiring Harness L.H.
1. Disconnect the alternator 2P connector (1) and B terminal (2).
2. Disconnect the starter motor C terminal (5) and B terminal (4).
3. Disconnect the engine oil pressure switch terminal (3).
Bonnet Support
1. Remove the bonnet support (1).
2. Remove the support frame (2).
(When reassembling)
(1) Accelerator Rod (3) Suction Pipe
(2) Delivery Pipe (4) Delivery Pipe
0000003414E
(1) Coolant Thermo Sensor 1P (3) 3P Connector for Solenoid
Connector Valve
(2) Wiring Lead for Glow Plug (4) Fuel Pipe
0000003415E
Tightening torque
Starter's terminal B
mounting nut
8.8 to 11.8
0.9 to 1.2
6.5 to 8.7 ft-lbs
(1) Alternator 2P Connector (4) Starter Motor B Terminal
(2) Alternator B Terminal (5) Starter Motor C Terminal
(3) Engine Oil Pressure Switch
Terminal
0000003417E
Tightening torque
Bonnet support
mounting screw
48.1 to 55.8
4.9 to 5.7
35.5 to 41.2 ft-lbs
Support frame mounting
screw
48.1 to 55.8
4.9 to 5.7
35.5 to 41.2 ft-lbs
(1) Bonnet Support (2) Support Frame
0000003418E
KiSC issued 04, 2006 A