Kubota ME8200DTN, Workshop Manual Supplement

Page: 76 / 192

ME8200DTN, WSM TRANSMISSION
N3-S12
Pedal Frame
1. Disconnect the main speed change rod 1 (3) and 2 (2).
2. Disconnect the shuttle rod (5).
3. Remove the mounting screws and remove the pedal frame (6)
with the main speed change lever assembly (1) and steering
controller.
4. Remove the mounting screw and remove the shuttle lever (7).
(When reassembling)
A
Adjust the length of shuttle rod (5), main speed change rod 1
(3) and 2 (2).
A
After adjusting the rod length, execute the following "Adjusting
the stopper bolts".
(Adjusting the stopper bolts)
1. Loosen the stopper bolts (2), (3) fully.
2. Shift the main speed change lever (1) fully left, and maintain it.
3. Screw in the lower stopper bolt (3) fully with the lever (1)
shifted left. (Refer to the photograph.)
4. Screw in the lower stopper bolt (3) one half turn more, and
tighten the lock nut.
5. Shift the main speed change lever (1) fully right, and adjust the
upper stopper bolt (2) according to the same procedure.
(C) Disassembling Clutch Housing
Length of main speed
change rod 1 (L1)
Factory spec.
145 mm
5.71 in.
Length of main speed
change rod 2 (L2)
Factory spec.
61 mm
2.40 in.
Length of shuttle rod
(L3)
Factory spec.
Approx. 160 mm
6.3 in.
(1) Main Speed Change Lever (4) Speed Change Cover
Assembly (5) Shuttle Rod
(2) Main Speed Change Rod 2 (6) Pedal Frame
(3) Main Speed Change Rod 1 (7) Shuttle Lever
0000003467E
(1) Main Speed Change Lever (3) Stopper Bolt
(2) Stopper Bolt
0000003468E
KiSC issued 04, 2006 A