Kubota ME8200DTN, Workshop Manual Supplement

Page: 186 / 192

ME8200DTN, WSM ELECTRICAL SYSTEM
N9-S3
4WD / Bi-speed Relay
1. Remove the 4WD / Bi-speed relay (4).
2. Apply battery voltage across 1 and 2 terminals, and check for
continuity across 3 and 5 terminals.
3. If continuity is not established across 3 and 5 terminals, relay
is faulty.
A
The 4WD / Bi-speed relay (4), PTO relay (3), relay 1 (2) and
key stop relay (1) are interchangeable each other.
Turning Angle Inspection Switch
1. Remove the switch cover (3) from the left side front case
support (4).
2. Disconnect the turning angle inspection switch connector (2)
after turning the main switch off.
3. Perform the following checking 1) and 2).
1) Connector Voltage
1. Turn the main switch ON position.
2. Set the 4WD / Bi-speed switch to Bi-speed position.
3. Measure the voltage with a voltmeter across the wiring
harness connector B terminal and chassis.
4. If the voltage differs from the battery voltage (11 to 14 volts),
check the 4WD / Bi-speed switch or wiring harness.
(1) Key Stop Relay (3) PTO Relay
(2) Relay 1 (4) 4WD / Bi-speed Relay
0000003559E
(1) Turning Angle Inspection (3) Switch Cover
Switch
(2) Connector (4) Front Case Support
0000003380E
Voltage
Connector B terminal
Chassis
Battery voltage
(1) Turning Angle Inspection (3) 1P Connector
Switch (Wiring Harness Side)
(2) 1P Connector (Switch Side)
0000003381E
KiSC issued 04, 2006 A