Kubota ME8200DTN, Workshop Manual Supplement

Page: 74 / 192

ME8200DTN, WSM TRANSMISSION
N3-S10
Rear Wheel, Fender and ROPS
1. Remove the seat (11).
2. Check the transmission case are securely mounted on the
disassembly stands.
3. Disconnect the connector (9) for hazard and tail lights.
4. Disconnect the connectors (5) for PTO safety switch.
5. Remove the rear wheels (1).
6. Disconnect the position rod (3) and draft rod (4).
7. Remove the PTO control wire (6).
8. Remove the fender (2) and center cover (10).
9. Remove the rear ROPS (8) with fuel tank (7).
(When reassembling)
A
Adjust the hydraulic control levers after reassembly when
you remove the right fender and the lever guide.
Length of position rod
(L1)
Factory spec.
206 mm
8.11 in.
Length of draft rod
(L2)
Factory spec.
172 mm
6.77 in.
Tightening torque
Rear wheel mounting
nut
260 to 304
26.5 to 31.0
192 to 224 ft-lbs
Rear ROPS mounting
U-bolt
196 to 225
20 to 23
144.7 to 166.4 ft-lbs
(1) Rear Wheel (7) Fuel Tank
(2) Fender (8) Rear ROPS
(3) Position Rod (9) Connector
(4) Draft Rod (10) Center Cover
(5) Connector (11) Seat
(6) PTO Control Wire
0000003464E
KiSC issued 04, 2006 A