Kubota ME8200DTN, Workshop Manual Supplement

Page: 187 / 192

ME8200DTN, WSM ELECTRICAL SYSTEM
N9-S4
2) Turning Angle Inspection Switch
1. Remove the switch cover (1).
2. Disconnect the two 1P connectors, and remove the turning
angle inspection switch (2) from the front case support (4).
3. Measure the resistance with an ohmmeter across the two 1P
connectors.
4. If infinity is not indicated, the turning angle inspection switch is
faulty.
5. Measure the resistance with an ohmmeter across the two 1P
connectors while pushing the push rod of switch.
6. If 0 ohm is not indicated, the turning angle inspection switch is
faulty.
A
After reassembling the Bi-speed turn sensor, be sure to
check its operation.
1. When the front wheels are straight ahead, the resistance
value of the turn angle inspection switch is infinity.
2. When the turning angle exceeds approximately 34 (0.59
rad.), the resistance value of the turning angle inspection
switch is o ohm.
If the resistance values specified above are not indicated,
adjust with the shim (3).
(Reference)
A
Thickness of adjusting shims : 0.5 mm (0.020 in.)
1.0 mm (0.039 in.)
4WD / Bi-speed Valve
1. Disconnect the 4P connector (1) after turning the main switch
off.
2. Perform the following checks.
Resistance across
two 1P connectors
Factory spec.
When the push rod is
normal position
Infinity
When the push rod is
pushed
0 ohm
(1) Switch Cover (3) Shim
(2) Turning Angle Inspection (4) Front Case Support
Switch
0000003382E
(1) 4P Connector (2) 4WD / Bi-speed Valve
0000003567E
KiSC issued 04, 2006 A