Kubota ME8200DTN, Workshop Manual Supplement

Page: 72 / 192

ME8200DTN, WSM TRANSMISSION
N3-S8
Separating Engine from Clutch Housing
1. Hoist the engine by the hoist and chain.
2. Remove the engine mounting screws and nuts, and separate
the engine from the clutch housing.
(When reassembling)
A
Apply molybdenum disulphide (Three Bond 1901 or
equivalent) to the splines of clutch disc boss.
A
Apply liquid gasket (Three Bond 1141, 1211 or equivalent) to
joint face of the engine and clutch housing.
Draining Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When reassembling)
A
Fill up from filling port after removing the filling plug until
reaching the dipstick.
A
After running the engine for few minutes, stop it and check the
fluid level again, add the fluid to prescribed level if it is not
correct level.
A
Use only KUBOTA SUPER UDT fluid. Use of other oils
may damage the transmission or hydraulic system.
A
Refer to "LUBRICANTS, FUEL AND COOLANT" (See
page NG-2.)
A
Do not mix different brands fluid together.
Tightening torque
Engine and clutch
housing mounting screw
and nut 77.5 to 90.2
7.9 to 9.2
57.1 to 66.5 ft-lbs
Engine and clutch
housing mounting stud
bolt 38.2 to 45.1
3.9 to 4.6
28.2 to 33.3 ft-lbs
0000003239E
(B) Separating Clutch Housing Case and Transmission Case
Transmission fluid Capacity
33.0 L
34.88 U.S.qts
29.04 lmp.qts
(1) Drain Plug
0000003403E
KiSC issued 04, 2006 A