Krone 5XL-GD, Operating Instructions Manual

Page: 30 / 126

III - 8
Operation
3.7.3 Setting the cutting length
This adjustment is carried out centrally on the left hand
side of the wagon.
• Lowering the cutter unit (see chapter 4 page IV-7)
• Remove the ignition key and switch off the electrical
supply at the control box.
• Using the multipurpose spanner (4), switch the cutters
in or out until the desired number of cutters and
therefore the desired cutting length has been selected.
• Hang the multipurpose spanner in the transport retainer
again.
• Follow instructions in 3.7.6.
• Switch on the electrical system again.
• Bring the cutter back into the working position (see
chapter 4, page IV-7)
3.7.4 Switching cutters
Lifting the articulated tow-bar makes it
easier to work in comfort under the
vehicle. Secure the raised vehicle with
the supporting foot.
Lower the cutter unit fully
• Bring blade bar into maintenance position (see chapter
4, page IV-7)
Remove the ignition key and switch off the
electrical supply at the control box.
The safety lever (6) on each cutter safety device must be
released in order to remove the cutters (5). For this
purpose, the multipurpose spanner (4) must be used to
rotate both selector shafts so that their cams (1) and (2)
are pointing downwards.
The blades (5) can now be removed.
Wear protective gloves while taking out/
attaching the cutters!
KDW00031
KDW05142