Konica Minolta DRYPRO Model 793, Operation Manual

Page: 140 / 156

Ch.6 Troubleshooting
< 138 >
DRYPRO Vstage MODEL 793 Operation Manual Ver.1.01 2005.1
6-3-4 Film Jam in the Supply Tray
Error codes "E4110", "E4210", "E4310" indicate the film jam resulted from transport error
of the film from the Supply Tray.
Remove the jam film according to the following procedure.
If the film does not pop
up from the Supply
Tray, shake the Supply
Tray back and forth
several times
4
Push the Supply Tray back into the main unit
until it is locked.
- "READY" will be displayed in the message column
when the Supply Tray is pushed back deep enough
and locked, and the DRYPRO 793 becomes ready to
print.
2
Pull out the popped out Supply Tray. If the film
pops up through the gap of the Supply Tray, pull
and remove the film by hand.
Do not open the shutter when removing the jam film, otherwise it may cause an
accidental exposure of the film.
1
Touch the [ERROR RESET] button.
- The Supply Tray will pop out a few centimeters.
1
3
If the film does not pop up from the Supply Tray,
shake the Supply Tray back and forth several
times while holding the Shutter by hand to keep
the Shutter closed.