Konica Minolta bizhub PRESS 1052, User Manual

Page: 72 / 540

bizhub PRESS 1250/1052 2-58
2.5 Using Machine When Power Save LED Lights 2
2.5 Using Machine When Power Save LED Lights
If you find the Power Save LED lit, the machine is inactive due to the Power Save or Weekly Timer function.
You cannot operate the machine with either of the functions activated.
2.5.1 Operation to Enable the Machine
%
Press any key on the control panel .
%
If the machine makes no response with any key pressed on
the
control panel , press Power Save .
If Power Save has been activated, the machine will be ready for print-
ing.
If Weekly Timer has been activated, the Machine Screen will be dis-
played with the message [Timer interrupt mode / Please enter pass-
word] in the message area. Entering the password allows you to use
the machine temporarily.
d
Reference
The Power Save function has two modes: Auto Low Power and Auto Shut OFF. For details, see the following
description.
Power Save can also be activated manually. See page 2-59 for details.
2.5.2 Automatically Conserving Energy: Auto Low Power
Auto Low Power conserves energy by lowering the power consumption.
This function is activated automatically after a specified period of machine inactivity (factory default is 1
minute), with the
Power Save LED lit, touch panel turned off, and all other LEDs except Start LED on the
control panel turned off. The Start LED turns red, while the Power LED keeps green.
If the same period of time is specified for Auto Low Power and Auto Shut OFF, the machine power will be
shut off. The
touch panel will not go off if the Jam Position Screen or screen to operate duplex printing is
displayed.
d
Reference
The Utility Menu Screen allows you to change the set period of time for Auto Low Power (to 1 minute, 3 min-
utes, 5 minutes, 10 minutes, 15 minutes, 30 minutes, 60 minutes, 90 minutes, 120 minutes, or 240 minutes).
For details, see Section 7 of the POD Administrator's Reference.