www.kolidainstrument.com
143
3) Press OBS. to start measurement, the measured
results are marked with
*
.
OBS.
REC Coordinate
*N : 10.364 m
*E : 234.897 m
*Z : 49.098 m
*ZA 76°34′17″
*HAR 64°22′10″
Pt K2013
REC. OBS. OFFS AUTO
4) Press REC to record the measurement data which
is with *.
Input following data: Point number, code, target
height.
REC.
REC Coordinate
*N 10.364 m
*E 234.897 m
*Z 49.098 m
Pt： K2009
Tgt. h 1.800m
SAVE CODE
5) Check and confirm the result, press SAVE to
record data. System will creates a new point number
by adding “1” on the basis of last point number. user
can use this number directly or create another
number.
In order to avoid duplicate recording, the function
key REC will not show up until a new
measurement happens.
SAVE
REC Coordinate
N 10.364 m
E 234.897 m
Z 49.098 m
ZA 76°34′17″
HAR 64°22′10″
Pt K2013
OBS. OFFS AUTO
6) Press OBS to measure the coordinates again in
Record Mode.
OBS.
Dist
Fine[1]
N 3.735 m
E 3.224 m
Z 1.886 m
ZA 76°34′17″
HAR 64°22′10″
STOP
7) Press ESC to restore the “Record Mode Screen.”
ESC
Record（1/2）
1.Stn Data
2. Back Sight data
3. Angle data
4. Dist data
5. Coord data
6. Dist+Coord data
Perform distance measurement to record automatically by pressing: AUTO.
When this key is used, it is unnecessary to perform coordinate measurement in MEAS Mode. Press
AUTO on the “Record Mode Screen” to perform coordinate measurement and automatically
record the results. When this is done, the point number automatically increases 1 from the last
number and the code is unchanged. After measurement has been completed, the screen return to the
display which AUTO was not pressed yet.
To perform Offset measurement in Record Mode: OFFS
