RMS compact
39
Load from unit
Uploads the existing configuration from the RMS compact into the Viewer/Programmer. – NOTE: Unless
Autosave to Unit
is enabled (see below), this will overwrite any changes made in the configuration in the
viewer until
Save to Unit
has been executed.
Saving the Configuration to the RMS compact
Once all configuration options have been set, it is necessary to save the configuration to the RMS compact
,
by
selecting the
‘Save To
RMS compact
’
button. Selecting this button should send the configuration to the RMS
Compact, displaying a progress bar during the download.
Saving the configuration to a file for downloading into another RMS compact
Under the
Configure RMS compact
menu
, there are two options, called
Save to File
and
Load from file
,
this
enables the user to save the configuration of the RMS compact unit to a file on a PC or server. This
configuration file can then be recalled and downloaded into an alternative unit (or into the same unit for backup
purposes).
Once the configuration of the unit is complete, select the
Save to File
button from the
File
menu. You will then
be prompted for a file location and filename.
To recall this configuration file at a later time, just select the
Load from File
button and locate the file. The
settings form this file will be recalled into the Viewer/Programmer for downloading into another unit.
Saving Viewer Configuration
It is possible to save the configuration of the viewer/programmer software in addition to the configuration of the
RMS compact itself. This will save the following settings:
•
Poll
Rate
•
SNMP
Seetings
•
Any Actions set
•
SMS
Settings
•
Logging
settings
Selecting
Save Viewer Configuration
will prompt the user to save the config (.ini) file to a user defined
location.
Load Viewer Configuration
will restore settings made in this file.
Note:
There are two different software streams of the
RMS compact Viewer/Programmer software (version
1.x.x and version 2.x.x) – Version 1.x.x of the viewer WILL NOT support configuration files created on a
2.x.x version of the Viewer/Programmer. Configuration files created on Version 1.x.x ARE SUPPORTED
on Viewer/Programmer version 2.1.1 and above only.
Setup Menu
Configure Actions
This screen enables the user to setup pre-defined actions for each alarm using batch files. A batch file can be
run for each alarm generated by the RMS compact
,
including all input alarms (Contact Closures &
temp/humidity), plus boolean logic output alarms. Selecting the
Actions
menu, will display the following screen: