Knurr RMS compact, User Manual, Page: 15 / 64

RMS compact
15
Configuration
Serial Port Configuration
You are now ready to configure the RMS compact to work on your network. RMS compact is temporarily
connected to a PC with a terminal emulation package or to a dumb terminal.
Note:
Note: Note:
Note:
Refer to the Installation section for the proper setting of the hardware adapter, and for terminal program
settings prior to configuring the device.
Main Menu
From the main menu you can select to change the Network Configuration, i.e. enter the IP address, Gateway
address, and MIB system group; you can set the access controls of SNMP communities; set the NMS and trap
receiver configuration; configure temperature and humidity; configure contact closure setup, set output settings
and save the new values and exit the program.
Knuerr RMS compact version X.X.X
Embedded Agent Setup
1. Network Configuration
2. Net Access Configuration
3. NMS Configuration
4. Trap Host Configuration
5. Temp & Humidity Configuration
6. Contact Closure Configuration
7. Shutdown Targets Configuration
8. Restore Default Settings
9. Set Output and Boolean Settings
10. Exit Setup
Enter choice (ESC to exit):
Figure 11 Main Menu
Note:
Note: Note:
Note:
When configuration is complete, changes must be saved to take effect, by selecting ‘Exit Setup’
followed by ‘2’ to save.
To select any option on the Main Menu , enter the number of the option you want at the Choose at the
Enter
choice (ESC to exit):
prompt. The program displays the desired screen.
Network Configuration Group
To set the IP address, Gateway address, subnet mask, and other system configurations, type 1 at the prompt.
The following screen displays:
Knuerr RMS compact version X.X.X
Embedded Agent Setup
IP Address: 1.1.222.222
Net Mask: 255.255.0.0
Gateway: 0.0.0.0
Agent Location: <No sysLocation Set>
HTTP: enabled
HTTP username: admin
HTTP password: knuerr
Card Host Name: RMSC
Boot Type: DHCP
1. Change IP Address
2. Change Net Mask
3. Change Gateway
4. Change Agent Location
5. Change HTTP User Name
6. Change HTTP User Password
7. [en/dis]able HTTP daemon
8. Change Card Host Name
9. Change Boot Type
10. Exit Network Setup
Figure 12 Network Configuration Group
Note: Note: Note: Note:
The minimum requirement to operate RMS compact is to set the IP address (or have DHCP/BootP set
one), and to enter an NMS into the NMS table.