RMS compact
38
Firstly, the user may ENABLE or DISABLE traps for OFF to ON or ON to OFF transitions of the logic outputs,
plus change the REPEAT TIMERS if required.
Note
Note
Note
Note
:
The Minimum Setting for a Trap Repeat Timer is 30 seconds.
Relay Output Configuration
The final area of configuration is the settings for the physical relay outputs:
Figure 49: Relay Output Configuration
This screen enables the logic previously configured, to switch a physical output on the RMS compact
.
From this
screen, the physical outputs are ENABLED OR DISABLED and assigned a NAME.
The ‘File’ Menu
Connect & Disconnect
Selecting
Connect
will prompt the user to enter the IP address of the RMS compact required (see the beginning
of this section of the manual, titled
Configuration
.
Poll Rate
This defines how often the RMS compact is polled over the network. This will obviously have an impact on
network traffic, and should therefore be used with some care.
SNMP Settings
Selecting this option will display the following screen:
Figure 50: SNMP Default settings
Explanations of both settings are given in the window above.