Keysight U2741A, Programmer'S Reference Manual

Page: 157 / 169

SCPI Error Messages 12
Keysight U2741A Programmer’s Reference Guide 157
–105 GET not allowed
A group execute trigger is not allowed in a command string
–108 Parameter not allowed
More parameters were received than expected for the command. You may have entered an extra parameter, or
you added a parameter to a command that does not accept a parameter.
–109 Missing parameter
Fewer parameters were received than expected for the command. You omitted one or more parameters that are
required for this command.
–110 Command header error
An error was detected in the header
–111 Header separator error
A character that was not a valid header separator was found in the command string
–112 Program mnemonic too long
The header contains more than 12 characters
–113 Undefined header
A command was received that is not valid. You may have misspelled the command or it may not be a valid
command. If you are using the short form of the command, remember that it may contain up to four letters.
–114 Header suffix out of range
The value of the numeric suffix is not valid
–120 Numeric data error
Generic numeric data error
–121 Invalid character in number
An invalid character was found in the number specified for a parameter value
Example:
*ESE #2
–123 Exponent too large
A numeric parameter was found whose exponent was larger than 32,000
–124 Too many digits
The mantissa of a numeric parameter contained more than 255 digits, excluding leading zeros
–128 Numeric data not allowed
A numeric parameter was received but a character string was expected
Table 12-1 Command Errors (these errors set Standard Event Status register bit #5) (continued)
Error number Command errors