Keysight U2741A, Programmer'S Reference Manual

Page: 160 / 169

12 SCPI Error Messages
160 Keysight U2741A Programmer’s Reference Guide
–211 Trigger ignored
A Group Execute Trigger (GET) or *TRG was received but the trigger was ignored
–212 Arm ignored
An arming signal was received and recognized by the device but was ignored
–213 Init ignored
A request for a measurement initiation was ignored as another measurement was already in progress
–214 Trigger deadlock
A trigger source for the initiation of a measurement is set to GET and a subsequent measurement query is
received. The measurement cannot begin until a GET is received, but the GET would cause an INTERRUPTED error.
–215 Arm deadlock
The arm source for the initiation of a measurement is set to GET and a subsequent measurement query is received.
The measurement cannot begin until a GET is received, but the GET would cause an INTERRUPTED error.
–220 Parameter error
A data element related error occurred
–221 Settings conflict
A data element could not be executed because of the present instrument state
–222 Data out of range
A data element could not be executed because the value was outside the valid range
–223 Too much data
A data element was received that contains more data than the U2741A can handle
–224 Illegal parameter value
An exact value was expected but not received
–230 Data corrupt or stale
Possibly an invalid data. A new reading was started but not completed
–231 Data questionable
The measurement accuracy is suspect
–240 Hard ware error
The command could not be executed because of a hardware problem with the U2741A
–241 Hard ware missing
The command could not be executed because of missing hardware, such as an option
Table 12-2 Execution Errors (these errors set Standard Event Status register bit #4) (continued)
Error number Execution errors