Keysight U2741A, Programmer'S Reference Manual

Page: 118 / 169

7 STATus Subsystem
118 Keysight U2741A Programmer’s Reference Guide
STATus:OPERation[:EVENt]?
Syntax
STATus:OPERation[:EVENt]?
This command queries the event register for the Standard Operation Register
group. This is a read-only register and the bits are cleared when you read the
register.
Remarks
– The condition register bits reflect the current condition. If a condition goes
away, the corresponding bit is cleared in the condition register.
– The following table lists the bit definitions for the Standard Operation Register.
– Once a bit is set, it remains set until cleared by reading the event register or
the clear status (
*CLS
) command.
– The
*RST
command has no effect on this register.
NOTE
For more information on the SCPI Status System, see Chapter 2 .
Bit number Decimal value Definition
0 Calibration in Progress 1 U2741A is performing a calibration
1 to 3 Not Used Not Used 0 is returned
4 Measuring 16 U2741A is initiated, and is making, or about to make a
measurement
5 Waiting for Trigger 32 U2741A is waiting for a trigger
6 to 7 Not Used Not Used 0 is returned
8 Configuration Change 256 U2741A configuration has been changed
9 Not Used Not Used 0 is returned
10 Not Used Not Used 0 is returned
11 to 15 Not Used Not Used 0 is returned