Keysight U2741A, Programmer'S Reference Manual

Page: 159 / 169

SCPI Error Messages 12
Keysight U2741A Programmer’s Reference Guide 159
Execution Errors
The execution errors are listed in the table below.
–170 Expression error
Generic expression error
–171 Invalid expression
The expression data element was invalid
–178 Expression data not allowed
Expression data element was sent but is not allowed for this command
–180 Macro error
An error was encountered when defining a macro or executing a macro
–181 Invalid outside macro definition
A macro parameter placeholder was encountered outside of a macro definition
–183 Invalid inside macro definition
The program message unit sequence, sent with a *DDT or a *DMC command, is syntactically invalid
–184 Macro parameter error
A command inside the macro definition had the wrong number or type of parameters
Table 12-1 Command Errors (these errors set Standard Event Status register bit #5) (continued)
Error number Command errors
Table 12-2 Execution Errors (these errors set Standard Event Status register bit #4)
Error number Execution errors
–200 Execution error
Generic syntax error
–201 Invalid while in local
A command is not executable while the device is in local mode due to a hard local control
–202 Settings lost due to RTL
A setting associated with a hard local control was lost when the device changed to LOCS from REMS or to
LWLS from RWLS
–210 Trigger error
Generic trigger error