Kenwood TK-2170 SERIES, Function Reference

Page: 102 / 142

20 FLEETSYNC
90
Index Contents
Confidential FUNC (K)/Ver. 1.01
20.3.4 Status Message Stack
Status Message Stack can be used to store received
Status Messages in Stack Memory. The transceiver can
store a maximum of 5 Status Messages.
When a message is stacked, the “
” icon blinks. In this
case, a user can read the stored Status Message when
the transceiver enters Stack Mode.
(Refer to 20.6 Stack
on page 95.)
The transceiver can be configured to store Status
Messages by using KPG-101D.
Note: The transceiver can store a maximum of 5 Status Messages
and 1 Short Message.
„ Configuration using KPG-101D
• Configuring the Status Message Stack (Refer to
FPRG 6.12.2 General 2 Tab - Status Message
Stack.)
20.3.5 Status Message on Data Zone-
CH/GID
This function allows the transceiver to automatically
change the channel to the Data Zone-CH/GID to send a
Status Message.
The transceiver returns to the previous Zone-CH/GID
when the transceiver finishes sending the Status
Message. This function can be used to send data using
the specific Zone-CH/GID.
Status Message on Data Zone-CH/GID can be configured
to be enabled or disabled by using KPG-101D.
„ Configuration using KPG-101D
• Configuring the Status Message on Data Zone-
CH/GID (Refer to FPRG 6.12.3 Parameter Tab -
Status Message on Data Zone-CH/GID.)
20.3.6 Status Message Serial Output
Status Message Serial Output can be used to send the
status, caller’s Fleet and ID from the transceiver’s COM
port when the transceiver receives a Status Message.
The dispatcher can remote control the transceivers with
the PC. With this function, a user can check the caller
status by connecting an external device to the
transceiver.
Status Message Serial Output can be configured to be
enabled or disabled by using KPG-101D.
„ Configuration using KPG-101D
• Configuring the Status Message Serial Output
(Refer to FPRG 6.12.2 General 2 Tab - Status
Message Serial Output.)
20.3.7 Status List
The transmitted or received statuses must be pre-
programmed to use Status List. A maximum of 50
statuses can be stored in the Status List.
Status List can be configured by using KPG-101D. The
following items are available for the Status List.
Table 20-10 Status Type
„
Configuration using KPG-101D
• Configuring the Status List (Refer to FPRG 6.12.5
Status List Tab.)
Call Type Description
Status
Configure the status number. Select a status
number between 10 and 99.
Status Name
Configure the status name. It may be hard to
recognize the meaning of Status only with the
status number. Therefore, the status name
showing the contents of the status can be
assigned to a status. A maximum of 16
characters can be configured for the Status
Name.
Transmit
Inhibit
Enable or disable the transmit capability.
If the Status is configured for Transmit Inhibit,
the status does not appear on the Status
Selection window in Message Mode.