Keithley 2701, Service Manual

Page: 22 / 168

1-8 Performance Verification Model 2701 Service Manual
Model 2701 verification
Perform these tests to verify accuracy using the Model 2701 front panel terminals.
Verifying DC voltage
Check DC voltage accuracy by applying accurate voltages from the DC voltage calibrator to
the Model 2701 INPUT jacks and verifying that the displayed readings fall within specified
limits.
CAUTION Do not exceed 1000V peak between front terminals INPUT HI and
INPUT LO because instrument damage may occur.
Follow these steps to verify DC voltage accuracy:
1. Connect the Model 2701 HI and LO INPUT jacks to the DC voltage calibrator as
shown in
Figure 1-1 . Make sure the INPUTS switch is set to the FRONT position.
NOTE
Use shielded, low-thermal connections when testing the 100mV and 1V ranges to
avoid errors caused by noise or thermal effects. Connect the shield to the
calibrator’s output LO terminal.
Figure 1-1
Connections for Model 2701 DC volts verification
OUTPUT
HI
OUTPUT
LO
INPUT HI
Calibrator (Output DC Voltage)
Note: Use shielded, low-thermal cables
for 100mV and 1V ranges.
Model 2701
INPUT LO
!
Model 2701 Ethernet Multimeter / Data Acquisition System
RANGE
F
500V
PEAK
FRONT/REAR
3A 250V
AMPS
HI
INPUT
LO
SENSE
Ω
4 WIRE
INPUTS
350V
PEAK
1000V
PEAK
AUTO
SHIFT
LOCAL
POWER
RANGE R
EXIT ENTER DIGITS RATE
REL FILTER TRIG EX TRIG STORE RECALL
OPEN
DCV DCI
MATH O U T P U T RATIO
ACV ACI
Ω
2
Ω
4 FREQ
TEMP
CH AVG CONT PERIOD SENSOR
LIMITS ON/OFF DELAY HOLD
SAVE SETUP
CONFIG HALT
TYPE
LSYNC
TEST
MONITOR
STEP SCAN
OCOMP
CH-OFF CARD
CLOSE
Integra Series
RS-232 ETHERNET
CAT I