Keithley 2701, Service Manual

Page: 160 / 168

Model 2701 Service Manual Calibration Reference B-21
:SAVE
(:CALibration:PROTected:CARD1:SAVE)
Purpose
To save calibration constants in card EEROM after the calibration
procedure.
Format
:cal:prot:card1:save
Parameter
None
Description
The
:SAVE
command stores calculated calibration constants derived during
Model 7700 calibration in card EEROM. (EEROM is non-volatile memory.)
Calibration constants will be retained indefinitely once saved. Generally,
:SAVE
is sent after all other calibration steps (except for
:LOCK
).
NOTE
Card calibration will be only temporary unless the :SAVE command is sent to
permanently store calibration constants.
Example
:CAL:PROT:CARD1:SAVE
Save card calibration constants.
:STEP0
(:CALibration:PROTected:CARD1:STEP0)
Purpose
To perform Model 7700 calibration.
Format
:cal:prot:card1:step0 <temp>
Parameter
<temp> = Cold calibration temperature (˚C)
Description
:STEP0
performs temperature sensor calibration of the Model 7700. The
card must be allowed to cool down to ambient temperature before calibra-
tion. The cold temperature of the card must be measured and sent as the
<temp> parameter during calibration.
NOTE
Before calibrating the Model 7700, make sure that power has been removed from the
card for at least two hours to allow card circuitry to cool down. After turning on the
power during the calibration procedure, complete the procedure as quickly as possi-
ble to minimize card heating that could affect calibration accuracy.
Example
:CAL:PROT:CARD1:STEP0 23
Perform 7700 calibration.