Keithley 2700, User Manual, Page: 345 / 500

13-2 SCPI Signal Oriented Commands Model 2700 Multimeter/Switch System User’s Manual
The signal oriented measurement commands are used to acquire readings. You can use
these high level instructions to control the measurement process. These commands are
summarized in
Table 13-1 .
NOTE
When measurements are performed, the readings are fed to other enabled
operations.
Appendix D explains “ Data flow (remote operation) ” and provides
additional information on using FETCh?, READ?, and MEASure? to acquire
readings.
Table 13-1
Signal oriented measurement command summary
Command Description
CONFigure:<function> [<rang>], [<res>], [<clist>]
FETCh?
READ?
MEASure[:<function>]? [<rang>], [<res>], [<clist>]
Places the Model 2700 in a “one-shot” measurement
mode for the specified function.
Requests the latest reading.
Performs an ABORt, INITiate, and a FETCh?.
Performs an ABORt, CONFigure:<function>, and a
READ?. (See Note).
Channel list parameter:
<clist> = (@SCH)
where: S = Mainframe slot number (1 or 2)
CH = Switching module channel number (must be 2 digits)
Examples: (@101) = Slot 1, Channel 1
(@101, 203) = Slot 1, Channel 1 and Slot 2, Channel 3
(@101:110) = Slot 1, Channels 1 through 10
Note: Only one channel can be specified in the <clist> for the MEASure? command.