![background image](http://html1.mh-extra.com/html/karcher/km-170-600-r-lpg/km-170-600-r-lpg_manual_655039029.webp)
-
11
Install new roller brush. The nuts of the
roller brush must be inserted on the
notches of the opposite crank.
Note:
When installing the new roller
brush, ensure correct positioning of the
bristle assembly.
Installation position of roller brush in direction of
travel (top view)
Note:
Once the new roller brush has been
installed, the sweeping track must readjust-
ed.
Check tyre pressure.
Switch off suction blower.
Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
Set the programme switch to sweep
with roller brush.
Set programme selection switch to
"Transport drive".
Drive machine backwards.
Check sweeping mirror.
The sweeping track should have an even
rectangular shape which is 80-85 mm wide.
Adjusting the sweeping track:
1
Brush roller adjustment
Adjust the sweeping track via the roller
brush adjustment.
Turning in (–) direction: Roller brush ris-
es.
Turning in (+) direction: Roller brush is
lowered.
Check sweeping mirror.
Check tyre pressure.
The side-brushes lift up.
Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
Set the programme switch to sweep
with roller brush and side brush.
The side-brushes lift up.
Set programme selection to "Drive".
Drive machine backwards.
Check sweeping mirror.
The width of the sweeping track should lie
between 40-50 mm.
Set the sweeping track using the two
adjusting screws.
Check sweeping mirror.
Check tyre pressure.
Drive the waste container up and se-
cure it with the safety rod.
Danger
Risk of injury! Always apply the safety bar
when the waste container is raised.
Fold the safety rod for the high empty-
ing up and insert it into the holder (se-
cured).
1
Holder of safety rod
2
Safety rod
Open the side cover as described in
Chapter "Replace brush roller".
Release the 6 wing nuts on the side
holding plate.
Loosen 3 nuts (SW 13) on the front
holding plate.
Press the side seal down (elongated
hole) until it is about 1 to 3 mm to the
floor.
Screw in the holding plates.
Repeat the procedure on the other side
of the appliance.
Park the sweeper on an even surface.
Connect air pressure testing device to
tyre valve.
Check air pressure and adjust if re-
quired.
For permissible tyre inflation pressure
see Chapter "Technical specifications".
Clean the dust filter with the filter clean-
ing button.
몇
Warning
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
1
Lock of appliance hood
2
Cover
Open the lock, remove the star grip
screw to do this.
Fold cover forwards.
1
Locking
2
Filter cover
Open the lock.
Open filter cap.
Fold the filter vibrator forward.
Check and adjust roller brush sweeping
track
80 - 85 mm
Check and adjust sweeping track of the
side-brush
Adjust the side seals
Check the tyre pressure
Manually clean the dust filter
Replacing dust filter
1
2
2
1
28
EN
Summary of Contents for KM 170/600 R LPG
